BRAND NEW AEM EMS-4
CONTACT CASRIC AUTO PARTS 352-5575
AEM’s EMS-4 Universal Standalone engine management system is designed for Powersports and 4-cylinder race vehicles. This affordable, lightweight, compact and powerful system features robust Series 2 EMS hardware in a weather and shock proof enclosure, with a 36-pin connector specifically designed to survive harsh racing environments.
The EMS-4 has all of the features you need and nothing you don’t (like AC, power locks, stereo, etc.) for dedicated 4-cylinder racecars, motorcycles, quads, side by sides or other race vehicles up to four cylinders.
Injector/ Coil Outputs
Injector Outputs (8 ohm minimum, High Impedance Only) 4 Saturated
Coil Triggers 0-5V Falling Edge Fire (Do not connect to coil primary) 4
Timing Sensor Inputs
VR (Mag) Cam Input 1
VR (Mag) Crank Input 1
Hall VSS Input 1
Hall Crank Input 1
Hall Cam Input 1
Inputs/Outputs
GPIO - 1.5A Low Side Output / 0-5V Analog Input / Switch Input 4
GPIO - 1.5A Low Side Output / 0-5V Analog Input / PWM Output 4
O2 Sensor Input 0-5V Analog 1
Knock Sensor Input Programmable 1
Throttle Position Sensor Input 0-5V 1
Manifold Pressure Sensor Input 0-5V 1
Coolant Temperature Sensor Input 0-5V 1
Inlet Air Temperature Sensor Input 0-5V 1
Sensor Ground 1
5 Volt Reference 1
Communication
USB comms Yes
Communication cables included Yes
Fully enabled editing/logging software included Yes
CAN bus equipped with Programmable Send / Receive Yes
CAN data stream output 32 ch
DATA Acquisition
Internal data logging 8 MB
Maximum internal logging rate (per channel) 125 Hz
PC logging Yes
Data analysis using AEMLog Yes
Functions and Features
User adjustable knock sensor center frequency Yes
Individual cylinder ignition trims Yes
Individual cylinder fuel trims Yes
High/Low speed fuel pump support Yes
All channels/maps/tuning options unlocked Yes
Boost control Yes
Groundspeed based boost target Yes
Nitrous injection Yes
Staged injection Yes
Ground speed limiting Yes
Rate of Acceleration Control Yes
Overrun boost enhancement (anti-lag) Yes
Gear change ignition cut (shift-without-lift) Yes
Password protected calibrations Yes
Fuel & Ignition rev limiters Yes
"In cockpit" global fuel trim capability Yes
Gear dependent shift light Yes
Evap/Purge function Yes
Software definable "virtual" switch inputs Yes
EGT Based fuel trims (additional hardware needed) Yes
Maximum boost limit None
Physical Dimensions
Length 120 mm
Width 114 mm
Height 35 mm
Finish Black
Price 110k
N.B. - Wireharness NOT included